BLWKW - FORMULA 27
- MSDS: BLWKW
- Manufacturer: FIBRE GLASS EVERCOAT CO INC
- Product Name: FORMULA 27
- National Stock Number: 8030-00N017477
Product Identification
Product ID:FORMULA 27
MSDS Date:08/09/1988
FSC:8030
NIIN:00N017477
MSDS Number: BLWKW
Responsible Party
CINCINNATI, OH 45242-2033
US
Emergency Phone: 800-543-4530
Info Phone: 513-489-7600
Cage: 18731
Contractor
Telephone: 513-489-7600
Cage: 18731
Ingredients
STYRENE
CAS: 100-42-5
RTECS: WL3675000
Fraction By Weight: <20%
OSHA PEL 100 PPM
ACGIH TLV: S,50PPM/100STEL;9293
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
TALC (POWDER), CONTAINING NO ASBESTOS FIBERS; (TALC)
CAS: 14807-96-6
RTECS: WW2710000
Fraction By Weight: <50%
OSHA PEL 2 MG/M3 (RDUST)
ACGIH TLV: 2 MG/M3 (RDUST)
UNSATURATED POLYESTER RESIN
Fraction By Weight: <40%
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: SKIN: PRLNGD/FREQUENT CONTACT
MAY CAUSE DEFAT, DRYNESS W/IRRIT, & POSS DERM. STYRENE MAY BE
ABSORBED THROUGH SKIN IN TOXIC AMTS. EYES: MAY CAUSE TEARING/IRRIT.
INHAL: VAPORS MAY CAUSE NOSE,THRO AT & RESP TRACT IRRIT. HIGH CONC
MAY CAUSE HDCH & NAUSEA. INGEST:MAY CAUSE GI DISTURBANCE, PAIN &
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:STYRENE:GROUP 2B (IARC).
Effects of Overexposure:HLTH HAZ:DISCOMFORT. CHRONIC: REPEATED
INHALATION OF HIGH CONCENTRATIONS MAY CAUSE LIVER/KIDNEY DAMAGE.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:SKIN: WASH W/SOAP & WATER. EYES: FLUSH W/WATER FOR AT LEAST
15 MIN. GET MD ATTEN. INHAL: REMOVE VICTIM FROM EXPOSURE. IF VICTIM
IS UNCONSCIOUS GIVE ARTIFICIAL RESPIRATION OR OXYGEN AS NEEDED. GET
MD A TTEN. INGEST: DO NOT INDUCE VOMITING (ASPIRATION HAZARD). GET
MD ATTENTION.
Fire Fighting
Flash Point Method:CC
Flash Point:98.0F,36.7C
Lower Limits:1.1
Upper Limits:6.1
Extinguishing Media:WATER SPRAY, FOAM, DRY CHEMICAL, OR CO*2.
Fire Fighting Procedures:FIRE FIGHTERS EXPOSED TO VAPORS OR PROD OF
COMBUSTION SHOULD WEAR NIOSH/MSHA APPPOVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:AT ELEVATED TEMPS SUCH AS IN A FIRE,
POLYMERIZATION MAY TAKE PLACE. IF CONTAINED, VIOLENT RUPTURE MAY
RESULT.
Accidental Release
Spill Release Procedures:REMOVE SOURCES OF IGNITION. ABSORB SPILL WITH
ABSORBENT MATERIAL SUCH AS VERMICULITE OR SAND.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:AVOID STORAGE ABOVE 100F. STORE ONLY
IN ORIGINAL CONTAINERS.
Other Precautions:STYRENE IS SUBJECT TO REQUIREMENTS OF SARA TITLE III,
SEC 313; AND 40 CFR 372.
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPROVED CANISTER TYPE RESPIRATOR
MUST BE WORN TO PREVENT INHAL OF VAPORS OR SPRAY MISTS WHEN TLV OR
PEL IS EXCEEDED. WEAR APPROVED DUST MASK WHEN SANDING CURED
PRODUCT.
Ventilation:GENERAL (MECH) VENTILATION IS REQUIRED DURING NORMAL USE.
Protective Gloves:PLASTIC/CHEMICAL RESISTANT GLOVES.
Eye Protection:CHEM WORK GOG & FULL LENGTH FSHLD.
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
Chemical Properties
Boiling Pt:B.P. Text:295F,146C
Vapor Pres:4.3
Vapor Density:HVR/AIR
Spec Gravity:1.8
Evaporation Rate & Reference:SLOWER (BUTYL ACETATE=1)
Solubility in Water:NIL
Appearance and Odor:PASTE, SHARP AROMATIC ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
HEAT & DIRECT SUNLIGHT.
Stability Condition to Avoid:STRONG ACIDS & OXIDIZING AGENTS
Hazardous Decomposition Products:HEATING TO DECOMP MAY CAUSE THE
EMISSION OF IRRITATING ACRID FUMES.
Conditions to Avoid Polymerization:AT ELEVATED TEMPS (FIRE)
POLYMERIZATION MAY TAKE PLACE.
Disposal
Waste Disposal Methods:SMALL QUANTITIES CAN BE REACTED WITH APPROPRIATE
HARDENER TO SOLIDIFY. DISPOSE IN ACCORDANCE WITH ALL FEDERAL, STATE
AND LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.